Electrical holding magnet Bar 401,5x32x31mm M6 24VDC 4700N

Qty: - OR - Add to Wish List
Add to Compare

Deliery time normally ~1 week

Electrical holding magnet
Thread	7xM6
Hold force [N]	4700
Thread MxL	M6x10
ED [%]	100
Power [W]	24
Voltage [V]	24DC
IP-code	IP65
Weight	2.6kg
Magnet properties
Magnet type	Electrical holding magnet Bar
Length [mm]	401.5
Width [mm]	32
Thickness [mm]	31

Description

Electrical holding magnet Bar 401,5x32x31mm M6 24VDC 4700N

The stated holding force applies in ideal conditions without a safety factor, on a 8mm thick iron plate of the material S235JR.

ED's is a percentage measure of the connection time. If the magnet are supposed to work shorter (lower ED), you can increase voltage and get more power. Lower voltage gives lower holding force.

Steel plate thickness: a = 8mm / b = 3mm / c = 1.5mm

INSTRUCTIONS FOR USE

The holding force (necessary to release the electromagnet in a perpendicular direction from the iron surface) depends on the following factors:

The gap between the electromagnet and the iron surface. The holding power is most optimal if both the surface of the magnet and the iron have direct contact, with as good surface evenness as possible.

The thickness of the iron surface. The electromagnetic force is most optimal if the thickness of the iron load exceeds 15mm.

Material. The material must be ferromagnetic. Good ferromagnetic material, from better to worse in descending order: Fe 35, steel 60, moldable cast iron, gray iron and high speed steel.

Voltage. The voltage should not be less than 90% of 24DC.

Here we can see how the magnetic field is affected when the iron plate thickness is > 8mm.

HYAB Magneter AB © 2021
Ranhammarsvägen 5 168 67 Bromma Sweden
Tel:+46 8 26 10 80 · Fax: +46 8 26 04 60 · E-Mail: [email protected]