Electrical holding magnet Bar 501,5x60x50mm M8 24VDC 9300N

Qty:     - OR -   Add to Wish List
Add to Compare
Electrical holding magnet
Thread 4xM8
Hold force [N] 9300
Thread MxL M8x21
ED [%] 100
Power [W] 75
Voltage [V] 24DC
IP-code IP67
Weight 9.3kg
Magnet properties
Magnet type Electrical holding magnet Bar
Length [mm] 501.5
Width [mm] 60
Thickness [mm] 50

Electrical holding magnet Bar 501,5x60x50mm M8 24VDC 9300N

The stated holding force applies in ideal conditions without a safety factor, on a 15mm thick iron plate of the material Fe35.

ED's is a percentage measure of  the connection time. If the magnet are supposed to work shorter (lower ED), you can increase voltage and get more power. Lower voltage gives lower holding force.
 
INSTRUCTIONS FOR USE
The holding force (necessary to release the electromagnet in a perpendicular direction from the iron surface) depends on the following factors:
 
The gap between the electromagnet and the iron surface. The holding power is most optimal if both the surface of the magnet and the iron have direct contact, with as good surface evenness as possible.
 
The thickness of the iron surface. The electromagnetic force is most optimal if the thickness of the iron load exceeds 15mm.
 
Material. The material must be ferromagnetic. Good ferromagnetic material, from better to worse in descending order: Fe 35, steel 60, moldable cast iron, gray iron and high speed steel.
 
Voltage. The voltage should not be less than 90% of 24DC.
 
Here we can see how the magnetic field is affected when the iron plate is less than recommended.

HYAB Magneter AB © 2021
Ranhammarsvägen 5 168 67 Bromma Sweden
Tel:+46 8 26 10 80 · Fax: +46 8 26 04 60 · E-Mail: [email protected]
EuroBizShop