Electrical Holding magnet Ring 56x6,6x13mm 24VDC 750N

Qty:     - OR -   Add to Wish List
Add to Compare
In Stock
Electrical holding magnet
Outer ØD [mm] 56
Thickness T [mm] 13
Hold force [N] 750
ED [%] 100
Power [W] 7.1
Voltage [V] 24DC
IP-code IP65
Weight 200g
Cable length [mm] 300
Magnet properties
Magnet type Electrical Holding magnet Ring

Electrical Holding magnet Ring 56x6,6x13mm 24VDC 750N

The difference between holding magnets and liftmagnets is that holding magnets do not have a safety factor. Note that holding magnets releases at given strength (in ideal conditions). Always use some margin.

Stated force applies in ideal conditions without safety factor.
Force: 1kg ≈ 9.8Newton

ED's is a percentage measure of  the connection time. If the magnet is supposed to work shorter period of time (lower ED), you can increase voltage and get more power. Lower voltage gives lower force.

 

Steel plate thickness: a = 1.5mm / b = 4mm

INSTRUCTIONS FOR USE
The holding force (necessary to release the electromagnet in a perpendicular direction from the iron surface) depends on the following factors:
 
The gap between the electromagnet and the iron surface. The holding power is most optimal if both the surface of the magnet and the iron have direct contact, with as good surface evenness as possible.
 
The thickness of the iron surface. The electromagnetic force is most optimal if the thickness of the iron load exceeds 15mm.
 
Material. The material must be ferromagnetic. Good ferromagnetic material, from better to worse in descending order: Fe 35, steel 60, moldable cast iron, gray iron and high speed steel.
 
Voltage. The voltage should not be less than 90% of 24DC.

HYAB Magneter AB © 2020
Ranhammarsvägen 5 168 67 Bromma Sweden
Tel:+46 8 26 10 80 · Fax: +46 8 26 04 60 · E-Mail: [email protected]
EuroBizShop